On more than one occasion we have talked about the bodywork of our car, as well as the paint. We have also talked about some methods to repair small scratches of our car. Today we are going to act as sheet metal workers and we are going to try fix a little bump in our car.
Surely on more than one occasion we have seen small sheet metal knocks in our car produced, on many occasions, by other vehicles when opening the door or that they can also be due to the fact that we have leaning on the plate and it has sunk.
In this situation, the first thing that comes to mind is take the car to sizer to get it repaired and in perfect condition again. At other times, we leave the blow for a long time without paying much attention to it.
However, we can fix this little bump ourselves in the body of our car in a simple and cheap way, with which we will keep the car in good condition for longer.
What do we need? Well, it will sound like a joke, but all we need is a powerful hair dryer and spray spray. Yes, believe me, with these two little things we will solve the small bumps in our car.
First of all we must clean the entire surface well on which we are going to work, so we will avoid possible scratches on our car. Then we must heat sheet metal surface with the dryer being careful not to damage the paint. We must heat the area of the blow for a few minutes until it is very hot and be careful with the plastic parts.
When the area of the blow is at a high temperature, we must shake the aerosol, turn it upside down and spray the entire surface of the blow that we want to repair.
Now is when the sheet metal automatically resumes its state, disappearing the blow that was in our car. The last step is to clean again the entire surface on which we have done the work.
It is a homemade solution that can save us the money of the sheet metal and with which we will achieve satisfactory results in a few minutes.
More information – Take care of your car paint, Repair scratches StickerFix
How certain are you that this would work? I've thought about doing it but here in my country (Venezuela) I don't know what type of Aerosol I should use. I've been looking for these videos for a long time and many people have done it. My confusion would be time to use the type of spray ... since I think it is not with any ...
Hello, I also want to know what type of spray I should use. Thank you very much
that is, what alternative is there to the CO2 spray that they place in the video
It doesn't work I tried it and nothing
Hello everyone, first of all a cordial greeting.
I would like to get them out of doubt, first of all:
1.- There is no type of spray on which to base ourselves, but rather any spray works! (Turns out when you turn a spray bottle upside down it will just spew air)
2.- When doing it with the aerosol, some incident may occur, such as staining the paint of our vehicle.
3.- I recommend using compressed air (the cans of air used to clean a computer)
you heat the affected area well and when you remove the hair dryer, you will apply compressed air and that's it
I recommend using spray deodorant such as Ax.